Warning
The page numbers for some of these references could not be added automatically. You must provide the page numbers from the original proceedings which is located at JACoW.org, and substitute ‘pp. XX-XX’ with the correct page numbers.
Favourites
For Word
[n] C. Weidemann, M. Bai, Y. Dutheil, F. Hinder, and B. Lorentz, “Calibration of Linear Optics of COSY Based on ORM Data”, in Proc. IPAC'17, Copenhagen, Denmark, May 2017, pp. 699-701. doi:10.18429/JACoW-IPAC2017-MOPIK073
[n] P. Leban et al., “New RF BPM Electronics for the 560 Beam Position Monitors of the APS-U Storage Ring”, in Proc. IPAC'21, Campinas, Brazil, May 2021, pp. 4325-4328. doi:10.18429/JACoW-IPAC2021-THPAB265
[n] M. N. Martins, A. L. Bonini, R. Lima, A. A. Malafronte, and T. F. Silva, “Commissioning of the 100 keV Beam Stage of the Injector Linac of the IFUSP Microtron”, in Proc. PAC'07, Albuquerque, NM, USA, Jun. 2007, paper THPMN003, pp. 2710-2712.
[n] H. Tongu et al., “Development of High Sensitive X-Ray Mapping for SC Cavities”, in Proc. IPAC'17, Copenhagen, Denmark, May 2017, pp. 1040-1042. doi:10.18429/JACoW-IPAC2017-MOPVA075
[n] M. A. Kempkes, J. A. Casey, M. P. J. Gaudreau, T. H. Hawkey, and I. Roth, “Solid-State 2MW Klystron Power Control System”, in Proc. PAC'05, Knoxville, TN, USA, May 2005, paper WPAT047, pp. 2950-2952.
[n] M.-H. Stodel et al., “Qualification and commissioning of superconducting magnets for the S3 spectrometer at GANIL”, presented at the IPAC'26, Deauville, France, May 2026, paper MOV7001, unpublished.
[n] M. J. Barnes, D. C. Fiander, and G. D. Wait, “Mathematical Modelling of the 1 MHz Beam Chopper for the Kaon Factory”, in Proc. EPAC'90, Nice, France, Jun. 1990, pp. 1275-1278.
[n] S. Fu, J. Li, H. C. Liu, H. F. Ouyang, and X. Yin, “Linac Construction for China Spallation Neutron Source”, in Proc. LINAC'12, Tel Aviv, Israel, Sep. 2012, paper THPB023, pp. 897-899.
[n] P. Forck, C. Andre, F. Becker, D. Hoffmann, and H. Iwase, “Profile Measurement by Beam Induced Fluorescence for 60 MeV/u to 750 MeV/u Heavy Ion Beams”, in Proc. EPAC'06, Edinburgh, UK, Jun. 2006, paper TUPCH010, pp. 1013-1015.
[n] D. B. Steski, K. A. Connell, O. Karban, and G. Tungate, “The Daresbury Polarized Heavy Ion Source”, in Proc. EPAC'90, Nice, France, Jun. 1990, pp. 662-665.
[n] M. Kwon, “Status of the Raon Heavy Ion Accelerator Project”, in Proc. IPAC'20, Caen, France, May 2020, paper TUVIR17, pp. XX-XX.
[n] H. Daniel, “Type Particle Acceleration by an RF Field”, in Proc. EPAC'94, London, UK, Jun.-Jul. 1994, pp. 823-826.
[n] D. Mathisen, “Shot Automation for the National Ignition Facility”, in Proc. ICALEPCS'05, Geneva, Switzerland, Oct. 2005, paper I2_002.
[n] K. T. McDonald and D. P. Russell, “A Beam-Profile Monitor for the BNL Accelerator Test Facility ( ATF)”, in Proc. PAC'89, Chicago, IL, USA, Mar. 1989, pp. 1510-1513.
For LaTeX
Use Complete Form
For BibTeX
References
- C. Weidemann, M. Bai, Y. Dutheil, F. Hinder, and B. Lorentz, “Calibration of Linear Optics of COSY Based on ORM Data”, in Proc. 8th Int. Particle Accelerator Conf. (IPAC'17), Copenhagen, Denmark, May 2017, pp. 699-701.
- P. Leban et al., “New RF BPM Electronics for the 560 Beam Position Monitors of the APS-U Storage Ring”, in Proc. 12th Int. Particle Accelerator Conf. (IPAC'21), Campinas, Brazil, May 2021, pp. 4325-4328.
- M. N. Martins, A. L. Bonini, R. Lima, A. A. Malafronte, and T. F. Silva, “Commissioning of the 100 keV Beam Stage of the Injector Linac of the IFUSP Microtron”, in Proc. 22nd Particle Accelerator Conf. (PAC'07), Albuquerque, NM, USA, Jun. 2007, paper THPMN003, pp. 2710-2712.
- H. Tongu et al., “Development of High Sensitive X-Ray Mapping for SC Cavities”, in Proc. 8th Int. Particle Accelerator Conf. (IPAC'17), Copenhagen, Denmark, May 2017, pp. 1040-1042.
- M. A. Kempkes, J. A. Casey, M. P. J. Gaudreau, T. H. Hawkey, and I. Roth, “Solid-State 2MW Klystron Power Control System”, in Proc. 21st Particle Accelerator Conf. (PAC'05), Knoxville, TN, USA, May 2005, paper WPAT047, pp. 2950-2952.
- M.-H. Stodel et al., “Qualification and commissioning of superconducting magnets for the S3 spectrometer at GANIL”, presented at the 17th Int. Particle Accelerator Conf. (IPAC'26), Deauville, France, May 2026, paper MOV7001, this conference.
- M. J. Barnes, D. C. Fiander, and G. D. Wait, “Mathematical Modelling of the 1 MHz Beam Chopper for the Kaon Factory”, in Proc. 2nd European Particle Accelerator Conf. (EPAC'90), Nice, France, Jun. 1990, pp. 1275-1278.
- S. Fu, J. Li, H. C. Liu, H. F. Ouyang, and X. Yin, “Linac Construction for China Spallation Neutron Source”, in Proc. 26th Linear Accelerator Conf. (LINAC'12), Tel Aviv, Israel, Sep. 2012, paper THPB023, pp. 897-899.
- P. Forck, C. Andre, F. Becker, D. Hoffmann, and H. Iwase, “Profile Measurement by Beam Induced Fluorescence for 60 MeV/u to 750 MeV/u Heavy Ion Beams”, in Proc. 10th European Particle Accelerator Conf. (EPAC'06), Edinburgh, UK, Jun. 2006, paper TUPCH010, pp. 1013-1015.
- D. B. Steski, K. A. Connell, O. Karban, and G. Tungate, “The Daresbury Polarized Heavy Ion Source”, in Proc. 2nd European Particle Accelerator Conf. (EPAC'90), Nice, France, Jun. 1990, pp. 662-665.
- M. Kwon, “Status of the Raon Heavy Ion Accelerator Project”, in Proc. 11th Int. Particle Accelerator Conf. (IPAC'20), Caen, France, May 2020, paper TUVIR17, pp. XX-XX.
- H. Daniel, “Type Particle Acceleration by an RF Field”, in Proc. 4th European Particle Accelerator Conf. (EPAC'94), London, UK, Jun.-Jul. 1994, pp. 823-826.
- D. Mathisen, “Shot Automation for the National Ignition Facility”, in Proc. 10th Int. Conf. on Accelerator and Large Experimental Physics Control Systems (ICALEPCS'05), Geneva, Switzerland, Oct. 2005, paper I2_002.
- K. T. McDonald and D. P. Russell, “A Beam-Profile Monitor for the BNL Accelerator Test Facility ( ATF)”, in Proc. 13th Particle Accelerator Conf. (PAC'89), Chicago, IL, USA, Mar. 1989, pp. 1510-1513.
Back to search